Visit ALWAYS WELCOME in Hyde Park to view our work.

< View all lamps

Sad Wall-Mounted Light

Previous Next
ZAR 2400
POWDER COATED SURFACES
Powder coating is a generally hard-wearing surface coating; it can however chip if dropped or knocked and anything sharp or rough can scratch it. Certain chemicals can damage a powder coated surface. Follow care instructions to protect this finish.
Open Instructions
Soak a soft cloth in lukewarm water mixed with a small concentration of pH-neutral detergent such as dishwashing liquid. Wipe dry afterwards.

Avoid using chemical, polish or oil treatments on furniture as they could damage or mark the surface.

Solvents such as nail polish remover or turpentine will damage the surface.

Don't use detergent containing ammonia or bleach. Don't use Handy Andy.

Use a soft cloth; don't use abrasive cleaning materials such as scouring pads.

Products are intended for interior use only, unless specified.

Prolonged exposure to moisture could affect the surface finish, especially if the powder coating has been damaged.
CERAMIC SHADES
Our ceramic shades are stoneware ceramic. They will chip if knocked hard or break if dropped.
Open Instructions
Use a low-heat LED or CFL globe.

Before cleaning be sure that the lampshade is not hot.

Dust regularly and then wipe clean with a soft cloth.
ELECTRICAL
Proper care of electrical products is essential to ensure user safety.
Open Instructions
Warm white, low-wattage LED globes are recommended.

Not suitable for outdoor use.

Avoid contact with liquids.

Don’t use if electrical components are damaged or loose.

Unplug product when cleaning.

Unplug product when changing the globe.
WALL-MOUNTED INSTALLATION
Open Instructions
Choose a sturdy fixing suitable for your wall (Drywall, plaster or brick). Test it before hanging product.

Before drilling into the wall, tape an open envelope below the spot to catch the dust.